• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print

Home > Radar Maintenance and Parts Manuals > > Electrical Test of Test Panel - continued - TM-11-6625-1831-130058
Electrical Test of Test Panel
Electrical Test of Test Panel - continued - TM-11-6625-1831-130059

TM-11-6625-1831-13 Radar Processor Interface Set TS-2973A/APS-94D (NSN 6625-01-085-4343) Manual
Page Navigation
  49    50    51    52    53  54  55    56    57    58    59  
TM 11-6625-1831-13
5-2b. Electrical Test of Test Panel (Cont)
LOCATION/ITEM
ACTION
REMARKS
1. TEST EQUIPMENT
Connect to test set as follows:
See illustration, next page.
a. Pulse generator No. 1
Connect through 100-ohm
termination to J5.
b. Pulse generator No. 2
Connect through 100-ohm
termination to J9.
c. Test fixture No. 1
Connect to J3.
d. Test fixture No. 2
Connect to J1.
e. Test fixture No. 3
Connect to J2.
f. Power supply
Connect to +5 Vdc and GND
jacks on test fixture No. 3.
WARNING
Avoid shock, ground the test set. Ensure that the ac line power plug is connected to a circuit
that has a protective earth (safety) ground.  Improperly grounded equipment can result in
hazardous voltage differences between pieces of equipment. Ensure that all devices connected
to the test set are connected to earth ground.
2. TEST EQUIPMENT
Prepare as follows:
a. Pulse generator No. 1
Connect to ac power.
Set power switch to ON.
Set for 5.0 + 0.01 MHz,
Use oscilloscope
5.0 + 0.1V peak-to-peak
and frequency
positive-going square-wave.
counter to set.
b. Power Supply
Connect to ac power.
Set power switch to ON.
Set for 5.0 + 0.1 Vdc output.
c. Pulse generator No. 2
Connect to ac power
3. MULTIMETER
Function selector
Set to resistance
RX100 range
5-5






Western Governors University
< Previous Page
Index ^
Next Page >

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.