Figure 3-24. Synthesizer test tray A1A3 module couplers alignment
Section III. ADJUSMENTS
a. Place tray A1A2 on its right side near the test set.
3-55. Tray A1 A2, IF Amplifier Subassembly A2
b. Remove the 16 bottom cover screws, and remove
the cover from tray A1A2.
To adjust IF amplifier subassembly A2 (fig. 3-20) of tray
c. Connect the banana pins of test cable W22 to test
A1A2 for 20 db, proceed as in a through i below.
points DC VOLTAGE + 20 and to