TM 11-5840-281-35/1
Control settings
Step No.
Test equipment
Equipment under test
Test procedure
Performance standard
B
167 max, 157 min.
b. Observe setting of ANGLE
VOLTS control dial.
a. None.
14
...............................As last indicated
a. On Pulse Generator 0-1333/
TPN-18 under test, adjust
ANGLE VOLTS control to
position cursor dot on 5-mi
range mark on artificial azimuth
sweep.
b. 164 max, 164 min.
b. Observe setting of ANGLE
VOLTS control dial.
15
...............................As last indicated -
a. None.
a. On Pulse Generator 0-1333/
TPN-18 under test, adjust
ANGLE VOLTS control to
position cursor dot on 6-mi
range mark on artificial azimuth
sweep.
b. 163 max, 153 min.
b. Observe setting of ANGLE
VOLTS control dial.
16
...............................As last indicated
a. None.
a. On top deck of Pulse Generator
O-1333/TPN-18 under test,
place CURSOR SELECT
switch to 2 and RUNWAY
switch to L.
b. None.
b. Set ANGLE VOLTS control
to 197.
c. None.
c. On top deck of Pulse Generator
O-1333/TPN-18, adjust
OFF-SET 2 control R1123 to
position cursor dot on 1-mi
range mark on artificial azimuth
sweep.
d. None.
d. Set ANGLE VOLTS control
to 158.
e. On top deck of Pulse Generator
e. None.
0-1333/TPN-18, adjust
COURSE LINE 2 control
R1127 and CL VER 2 control
R1144 to position cursor dot on
6-mi range mark on artificial
azimuth sweep.
f. Repeat steps b thru d until
f.
None.
cursor dot is positioned on 1-mi
range mark with ANGLE VOLTS
control set at 197 and posi-
tioned on 6-mi-range mark with
ANGLE VOLTS control set at
158 without readjustment of
OFF-SET 2 control R1123 and
COURSE LINE 2 control
R1127.
17..
...............................As last indicated, except:
On top deck of Pulse Generator
No appreciable difference
Pulse Generator
0-1333/TPN-18, place
between courseline cursor
0-1333/TPN-18
CURSOR SELECT switch
2 and courseline cursor 1
under test
S1104 back and forth to positions
(cursor 2 should be
ANGLE VOLTS switch:
I and 2 while observing course-
superimposed on cursor 1).
OPERATE
line cursor 1 and courseline
Master Pulse Generator
cursor 2 on azimuth scan.
O-01333/ TPN-18
SCAN: ON
4-56
Previous Page
