TM 11-5841-283-34-1/NAVAIR 16-30APR39-2
2-9. TEST ADAPTER SETUP.
The test adapter contains wire harnesses to connect any unit of radar signal detecting set to a
complete radar signal detecting set system. The test adapter has test points (TP) on the front
panel so that circuits in some units can be tested.
This task covers:
Test adapter setup
INITIAL SETUP
Equipment Condition
Test Equipment
Cover off unit tested. See
Test adapter
section Ill index for removal of
See appendix B, TM 11-5841-283-12
unit covers.
for test equipment needed for
troubleshooting.
ACTION
LOCATION
ITEM
REMARKS
CAUTION
Do not set test adapter power on when making or breaking unit
connections.
NOTE
All test equipment should be turned on at least 30 minutes
before use in troubleshooting so that test equipment will
measure properly.
1. Test adapter
Units (1)
Install.
2. Units
Cables (2)
Install.
A plastic band near each wire harness
connector shows where connection
should be made.
2-12
Previous Page
