TM 11-6625-847-45
CHAPTER 4
GENERA1 SUPPORT TESTING PROCEDURES
procedure and verify it against its performance standard.
4-1. General
If a performance standard is not met while testing a
a. Testing procedures are prepared for use by
module or subassembly, refer to the applicable
Signal Field Maintenance Shops and Signal Service
troubleshooting chart for corrective measures as indicated
Organizations
responsible
for
general
support
under the performance standard.
maintenance of signal equipment to determine the
acceptability of repaired equipment. These procedures
set forth specific requirements that repaired equipment
4-2. Test Equipment, Tools, and Materials
must meet before it is returned to the using organization.
b. Comply with the instructions preceding each chart
All test equipment, tools, materials, and other
equipment required to perform the testing procedures
before proceeding to the chart. Perform each step in
given in this section are listed in the charts in a through d
sequence. Do not vary the sequence. For each step,
below, and are authorized under TA 11-17, Signal Field
perform All the actions required in the Teat equipment
Maintenance Shops, and TA 11-100(11-17), Allowances
control settings column; then set the controls and switches
of Signal Corps Expendable Supplies for Signal Field
on the module or subassembly being tested to the
Maintenance Shop, Continental United States.
positions indicated in the Equipment under test control
settings column; then perform each specific test
a. Test Equipment.
Nomenclature
Federal stock No.
Technical manual
Multimeter AN/PSM-6B - ............................................ 6625-643-1688
TM 11 6625-475-10
Voltmeter, Electronic AN/URM-
6625-973-3986
TM 11-6625-524-14
145.
Electric Counter, Digital
6625-911-6368
TM 11-6625-700-10
Readout AN/USM-207.
None
Generator, Signal AN/URM-
6625-783-5965
TM 11-6625-683-15
127.
Oscilloscope AN/USM-140(*)- ..................................... 6625-066-2525
TM 11-6625-535-15
Generator, Signal AN/GRM-
6625-868-8353
TM 11-6625-573-15
Analyzer, Spectrum TS-723(*)/
6625-668-9418
TM 11-5097
U.
b. Tools.
ToolFederal Stock No.
107-1001 Inert tool, None
ToolFederal stock No. Winchester Inc.
Tool Kit, Electronic5180-605-0079
Winchester Crimp and
None
Equipment TK-100/G.
Extraction tool. Amp Inc.Crimp Tools
None
Tool Kit, Electronic Equip-5180-610-8177 Crimp Tool, Thomas &
None
ment TK-105/G.
Betes Co. No. WT-
GA 58037 Extraction5120-970-2722
219
tool, Cannon Electric
Screwdriver with screw- None
Co.
holding clip.
4-1
Previous Page
