Bulk and Consumable Materials. - TB-11-5840-384-200028

TB 11-5840-384-20

c. Bulk and Consumable Materials.

NOMENCLATURE

PART NO/NSN

U/I

QUANTITY REQ

SD-2

8. Special Tools, Jigs and Fixtures Required. Not applicable.

9. Inspection Procedures. Only applicable to Tactical Terminal Control System redeploying.

10. Cleaning Procedures.

NOTE

Keep in mind all warnings and cautions when performing any routine cleaning

Use dry cleaning solvent SD-2 on all metal surfaces. Use soap and water when you clean rubber or plastic

material. When cleaning grease, use an approved cleaning solvent and apply a thin coat of light oil to the

cleaned surfaces.

a. Using a lint-free cloth, clean exterior surfaces of equipment and mechanical assemblies.

b. With a clean lint-free cloth and soft-bristled brush, clean plugs, jacks, and front panel controls and

indicators. Meter faces and front panels may be cleaned using a weak solution of water and mild soap.

Avoid excessive amount of solution on cloth and do not let solution enter behind controls or panel

mounting hardware of controls and indicators.

Clean exterior and pins of connectors of interconnecting cables with a brush.

d. Equipment housings; racks, generator set, HMMWV (IAW TM 9-2320-280-10), trailer

(TM 9-2330-202-14&P)

1-22