TM 11-5840-208-30-1
(d) Set in the radar location data as follows:
1. Use the EASTING and NORTHING switches to set the RADAR LOCATION EASTING and
NORTHING counters to zero.
Note: If the correct radar location is already set into the EASTING and
NORTHING counters, it is not necessary to change them. Add the radar
easting and northing to the corresponding answers in the log book solutions
to these problems, and use these new figures for comparison with the test
results obtained in (e) through (r) below.
2. Set the RADAR HEIGHT counter to 300 meters.
(e) Set the radar on the proper angle of elevation.
(f) Set the DETENT switch to OFF.
(g) Place the A RANGE and A AZIMUTH controls in detent.
(h) Using the AZIMUTH switch and the LOWER BEAM AZIMUTH control, set in the proper azimuth.
(i) Set in the proper lower beam range.
(j) Turn the TEST-NORMAL switch to TEST.
(k) Set the DETENT switch to DETENT RELEASE.
(l) Set in the upper beam azimuth with the A AZIMUTH control.
(m) Set in the upper beam range with the A RANGE control.
(n) Turn the TEST-NORMAL switch to NORMAL.
(o) Set in the A time with the A TIME knob.
(p) Set the weapon height into the computer.
(q) Check the reading of the WEAPON LOCATION EASTING and NORTHING counters against the
most recent set of out-put data entered in the radar log book.
(r) Repeat the steps in (d) through (a) above for the remaining problems.
Page 22
Previous Page
