TM 11-5840-281-12-1
4-26.
SITING OF TARGET SIMULATORS. (CONT)
WARNING
Ensure placement of clr target reflector will not present any safety hazard to departing or approaching aircraft.
NOTE
Read and become familiar with siting procedure in steps 1 through 5 before attempting to site target simulators.
305NE217
1.
Determine clr (1) by measuring width of runway and dividing by two.
2.
Determine and record radar offset from clr distance (A) by measuring a straight line perpendicular to clr (1) to
center of radar set group (2).
3.
Determine and record distance to td (B) by measuring a straight line from radar set group (2) to td point (3). This
distance will be used in future cursor alinements (para 4-28).
4.
Position clr target reflector (4) on an extension of the clr (1) approximately 200 feet (61 m) beyond end of
runway.
5.
Extend a straight line from td point (3), toward radar set group side of runway and perpendicular to clr, that is the
same distance (dotted line A) as that recorded In step 2. Place td-rpl target reflector (5) at this point.
4-57
Previous Page
