TM 11-5840-298-34P-1
INTRODUCTION
NOTE
1. Scope
Cannibalization or salvage may be used
This manual lists spares and repair parts; special
as a source of supply for any items source
tools; special test, measurement, and diagnostic
coded above except those coded XA and
equipment (TMDE), and other special support
aircraft support items as restricted by
equipment required for performance of direct sup-
AR 700-42.
port, and general support maintenance of the
(2) Maintenance code. Maintenance codes are
AN/PPS-5A. It authorizes the requisitioning and
assigned to indicate the levels of maintenance
issue of spares and repair parts as indicated by the
authorized to USE and REPAIR support items. The
source and maintenance codes.
maintenance codes are entered in the third and
2. General
fourth positions of the Uniform SMR Code format
This Repair Parts and Special Tools List is divided
as follows:
into the following sections:
(a) The maintenance code entered in the third
a. Section II. Repair Parts List. A list of spares
position will indicate the lowest maintenance level
and repair parts authorized for use in the per-
authorized to remove, replace, and use the support
formance of maintenance. The list also includes par-
item. The maintenance code entered in the third
ts which must be removed for replacement of the
position will indicate one of the following levels of
authorized parts. Parts lists are composed of func-
maintenance:
tional groups in numeric sequence, with the parts in
Code
Application/Explanation
each group listed in figure and item number sequen-
OSupport item is removed, replaced, used at the
ce.
b. Section III. Special Tools List. Not ap-
FSupport item is removed, replaced, used at the
plicable.
direct support level.
HSupport item is removed, replaced, used at the
Number Index. A list, in National item iden-
general support level.
tification number (NIIN) sequence, of all National
DSupport items that are removed, replaced, used
stock numbers (NSN) appearing in the listings,
at depot, mobile depot, specialized repair ac-
followed by a list, in alphameric sequence, of all part
tivity only.
numbers appearing in the listings. National stock
(b) The maintenance code entered in the
numbers and part numbers are cross-referenced to
fourth position indicates whether the item is to be
each illustration figure and item number ap-
repaired and identifies the lowest maintenance level
pearance.
with the capability to perform complete repair (i.e.,
all authorized maintenance functions). This position
3. Explanation of Columns
will contain one of the following maintenance codes:
a. Illustration. This column is divided as follows:
Application/Explanation
Code
(1) Figure number. Indicates the figure number
FThe lowest maintenance level capable of com-
of the illustration on which the item is shown.
plete repair of the support item is the direct
(2) Item number. The number used to identify
support level.
item called out in the illustration.
HThe lowest maintenance level capable of com-
b. Source, Maintenance, and Recoverability
plete repair of the support item is the general
(SMR) Codes.
support level.
(1) Source code. Source codes indicate the man-
D--The lowest maintenance level capable of com-
ner of acquiring support items for maintenance,
plete repair of the support item is the depot
repair, or overhaul of end items. Source codes are en-
level.
tered in the first and second positions of the
ZNonreparable. No repair is authorized.
Uniform SMR Code format as follows:
(3) Recoverability code. Recoverability codes
Definition
Code
are assigned to support items to indicate the
PA--Item procured and stocked for anticipated or
disposition action on unserviceable items. The
known usage.
recoverability code is entered in the fifth position of
XD--A support item that is not stocked. When
the Uniform SMR Code format as follows:
required, item will be procured through nor-
mal supply channels.
Previous Page
