TM 11-5840-360-14-1-1
Table 2-13. Primary Power Input Test Points
Equipment
Input Voltage
Test Points
115V, 60Hz, 1∅
Receiver Transmitter RT-1240
FL2(+) and FL3(-)
115V, 60Hz, 1∅
Indicator IP-1282/IP-1283
FL1-1 and FL2-1
115V, 60Hz, 1∅
Interface Unit J-3463
TB1-1 and TB1-2
115V, 60Hz, 1∅
Amplifier-Generator AM-6933
TB1-1 and TB1-2
115V, 60Hz, 1∅
Signal Data Converter CV-3442
TB1-1 and TB1-2
115V, 60Hz, 1∅
Receiver Transmitter RT-1241
FL1 (Line) and FL2(Line)
440V, 60Hz, 3∅
K1L1, L2 and L3
2.17 TURN-ON PROCEDURES
2.18 INITIAL ADJUSTMENTS
2.17.1 AN/SPS-64(V) 1
2.18.1 General
The initial turn-on procedure for Radar Set
Initial adjustment procedures for Radar Set
AN/SPS-64(V) 1 is given in Chapter 3, paragraphs 3.2.1
AN/SP6-64(V) are given in Chapter 5 of this manual.
and 3.2.2.
set, the paragraph containing each procedure and the
2.17.2 AN/SPS-64(V) 2
sequence in which each procedure is to be performed.
The initial turn-on procedure for Radar Set
AN/SPS-64(V)2 is given in Chapter 3, paragraphs 3.3.1
2.18.2 V2 System Maintenance Modes
through 3.3.3.
When performing initial adjustments on
Receiver Transmitter RT-1240 for the V2 system, select
2.17.3 AN/SPS-64(V)3
the DP-5 or DP-6 maintenance mode (see Table 3-1).
The initial turn-on procedure for Radar Set
AN/SPS-64(V)3 is given in Chapter 3, paragraphs 3.4.1
2.18.3 Range Zero Calibration Modes
through 3.4.3.
When performing the range zero calibration on
Indicator IP-1282 or IP-1283 for the V2, V3 or V4
2.17.4 AN/SPS-64(V) 4
systems, at each indicator repeat the calibration for all
possible configurations (as master indicator; as slave
The initial turn-on procedure for Radar Set
indicator; controlling X-band receiver transmitter;
AN/SPS-64(V) 4 is given in Chapter 3, paragraphs 3.5.1
controlling S-band receiver transmitter) .
through 3.5.3.
2-67
Previous Page
