TM 11-5840-360-14-1-1
APPENDIX C
COMPONENTS OF END ITEM LIST
Section I. INTRODUCTION
C-1. Scope
b. National Stock Number. Indicates the National
stock number assigned to the item and which will be
This appendix lists integral components of and basic
used for requisitioning.
issue items for the AN/SPS-64(V)5 to help you inventory
c. Description. Indicates the Federal item name
items required for safe and efficient operation.
and, if required, a minimum description to identify the
item. The part number indicates the primary number
C-2. General
used by the manufacturer, which controls the design and
characteristics of the item by means of its engineering
This Components of End Item List is divided into the
drawings, specifications, standards, and inspection
following sections:
requirements to identify an item or range of items.
a. Section II. Integral Components of the End
Following the part number, the Federal Supply Code for
Item. These items, when assembled, comprise the
Manufacturers (FSCM) is shown in parentheses.
AN/SPS-64(V)5 and must accompany it whenever it is
d. Location. The physical location of each item
transferred or turned in. The illustrations will help you
listed is given in this column. The lists are designed to
identify these items.
inventory all items in one area of the major item before
b. Section III. Basic Issue Items. Not applicable.
moving on to an adjacent area.
e. Quantity Required (Qty Reqd). This column lists
C-3. Explanation of Columns
the quantity of each item required for a complete major
item.
a. Illustration. This column is divided as follows:
f. Quantity. This column is left blank for use
during an inventory. Under the Rcvd column, list the
(1) Figure number.
Indicates the figure
quantity you actually receive on your major item. The
number of the illustration on which the item is shown.
Date columns are for your use when you inventory the
(2) Item number.
The number used to
major item.
identify item called out in the illustration.
(Next printed page is C-2)
C-1
Previous Page
