TM 11-5841-283-34-1/NAVAIR 16-30APR39-2
2-16. GENERAL.
This section provides instructions for replacement of parts and assemblies for the following:
Control unit
Radar signal indicator
Receiver
Reference to this section is made when the testing and troubleshooting procedures of section II
show that a part or assembly is bad.
Typical procedures for the repair of the wire harness are given for the following:
Control unit
Radar signal indicator
If the CRT or yoke of the radar signal indicator is replaced, be sure to see paragraph 2-44 for
the alinement of the strobe.
Resources required are not listed unless they apply to the procedure.
Personnel are listed only if the task requires more than one. If personnel required is not
listed, one person can do the task.
2-45
Previous Page
