TM 115841-283-34-1/NAVAIR 16-30 APR
2-44. ALINEMENT OF RADAR SIGNAL INDICATOR STROBE. (CONT)
ACTION
REMARKS
ITEM
LOCATION
14. Radar signal
BRIL control (1)
Set control fully counterclockwise.
indicator
15. Receivers
Disconnect.
Cables (2)
16. Control unit
PWR ON-OFF
Set to ON.
switch (3)
17.
Press and hold.
SELF TEST
.
switch (4)
Slowly turn control clockwise until a dot
18. Radar signal
BRIL control (1)
indicator
appears on CRT screen.
and CRT screen (5)
Keep brilliance of dot to lowest
usable level.
19.
The dot must appear no more than 1/32 inch
CRT screen (5)
from center.
If not, follow steps 18 through 25.
2 0 . Control unit
Set to OFF.
PWR ON-OFF
Return radar signal indicator to
switch (3)
service. See paragraph 2-31 for insta-
Iation of cover.
21. Radar signal
Place magnet on yoke and move along surface
Magnet (6), yoke
indicator
until dot appears at center of CRT screen.
(7) and CRT
screen (5)
NOTE
Magnet may be on back of yoke on some units.
2 2 . Control unit
Release.
SELF TEST
switch (4)
Mark spot on yoke and remove magnet.
Magnet (6) and
23. Radar signal
indicator
yoke (7)
Apply adhesive on magnet and place magnet
Magnet (6)
24.
on marked spot.
Press and hold.
25.
SELF TEST
switch (4)
2-102
Previous Page
