TM 43-6625-916-12
RADAR TEST SET
0026 00
PREPARATION FOR STORAGE, MOVEMENT, AND SHIPMENT - Continued
NOTE
When discharging battery stick, it is necessary to disconnect the battery
charger from primary power.
d. Store battery stick(s) and External Battery Charger/Discharger in the slots provided in the transit case.
e. Store KIT/KIR-1C Interface Cable, RS-232 Cable, AC Power Cord, AC Adapter, and Direct Connect
Cable in central compartment of transit case.
f.
Store Test Set in transit case.
g. Check radar Test Set for completeness (WP0029 00).
h. Close the transit case lid and tighten the five case latches.
i.
If original packing material was saved, pack the radar Test Set in the same manner as it was received.
When using packing materials other than the original, repackage the instrument with commercially
available materials, as follows:
(1)
Use a strong shipping container. The carton must be both large enough and strong enough to
accommodate the TS-4530/UPM. Select a double-walled, corrugated cardboard carton with 159 kg
(350 lb). Allow at least 3 to 4 inches on all sides of the Test Set for packing material.
(2)
Surround the equipment with three to four inches of packing material and prevent the equipment
from moving in the carton. If packing foam is not available, the best alternative is a plastic sheet
filled with 1-1/4 inch air bubbles. Wrapping the equipment several times in this material should both
protect the equipment and prevent it from moving in the carton.
(3)
Seal the shipping container securely with strong nylon adhesive tape.
(4)
Mark the shipping container "FRAGILE, HANDLE WITH CARE" to assure careful handling.
(5)
Retain copies of all shipping papers.
END OF WORK PACKAGE
0026 00-2
Previous Page
