TM 43-6625-916-12
RADAR TEST SET
PREPARATION FOR STORAGE, MOVEMENT, AND SHIPMENT
PREPARATION FOR MOVEMENT
Prepare radar Test Set for movement as follows:
a. If connected, disconnect KIT/KIR-1C interface cable (PN: 55-1045-10) from Test Set.
b. Remove battery end cap and remove battery stick from Test Set.
Do not short positive and negative terminals together when handling NI-CAD
batteries. If you short the battery terminals, the battery cells may EXPLODE
and cause you INJURY or DEATH.
c. Store battery stick(s) and CDs in the slots provided in the transit case.
d. Store AC Adaptor, Battery Charger/Discharger, KIT/KIR Interface Cable, RS-232 Cable, AC Power Cord,
and Direct Connect Cable in the slots provided in the transit case.
e. Store Test Set in transit case.
f.
Check TS-4530/UPM for completeness (WP0029 00).
g. Close the transit case lid and tighten the five case latches.
PREPARATION FOR INACTIVE STORAGE OR SHIPMENT
Prepare radar Test Set for inactive storage or shipment as follows:
a. If connected, disconnect KIT/KIR interface cable from Test Set.
b. Remove battery end cap and remove battery stick from Test Set.
c. If required for shipment, discharge battery stick in accordance with battery stick discharging procedure
discharged state to maximize battery life.
Do not short positive and negative terminals together when handling NI-CAD
batteries. If you short the battery terminals, the battery cells may EXPLODE
and cause you INJURY or DEATH.
Test Set batteries must be removed from Test Set and placed in transit case
before shipment or inactive storage of 30 days or more. Extremely high
shipment or storage temperatures (greater than 100 degrees C) may cause
NI-CAD batteries in the battery stick to release toxic materials which are
hazardous to you.
Previous Page
