TM 11-5840-281-35/1
Control settings
Step No. Test equipment Equipment under test
Test procedure
Performance standard
6
As last
WARNING. Be careful when
NULL: VTVM, 10 to 1
indicated ----
performing the procedures In a
in progressive steps.
through e below. Test points
A, B, C, D, E: As
TP103 and TP104 are 130 vdc
required.
above ground potential.
a. None.
negative (-) test lead to
(-) testpoint TP104 on
Radar Receiver-Transmitter
RT-818/TPN-18.
b. None.
positive (+) test lead to (+)
testpoint TP103 on Radar
Receiver-Transmitter RT-
818/TPN-18.
c. Voltage indication on
c. On differential voltmeter,
differential voltmeter is
position A, B, C, D, and E
10 times current stamped
controls to obtain null.
on ferrite switch S102.
Example: Ferrite
switch is stamped 450
MA, 450 X 10 = 4500
mv=4.5v.
d. None.
d. Disconnect differential volt-
meter test leads.
Strong radar video returns
7 ------------------- As last indicated, except:
On Control-Indicator, C-6988/
Radar Receiver-
present on azimuth and
TPN-18, observe radar video
elevation displays.
Transmitter RT-
returns on azimuth and eleva-
818/
tion displays.
TPN-18
NOTE. Do not replace covers
SCAN: ON
HV: OPERATE
RT-818/TPN-18 until tests are
Master Pulse
completed.
O-1333/TPN-18
SCAN MODE: NORM
SCAN: ON
TRANSMITTER: Thru
WIDE to HV ON.
IF GAIN-AZ: Fully cw
IF GAIN-EL: Fully cw
EL TARGET: Fully ccw
4-7. Testing Electronic Filters and
(3) Clinometer MP3502 (clinometer)
b. Equipment Conditions.
(1) Radar Set AN/TPN-18 turned on.
(2) Front and rear covers removed from
a. Test Equipment Required.
(3) Clinometer MP3502 installed on elevation
scope).
c. Procedure.
Control settings
Step No. Test equipment Equipment under test
Test procedure
Performance standard
Vivm
Radar Receiver-
a. Manually position elevation
a. None
1
Transmitter RT-818/
SELECTOR: +
to scan angle of -1 as indi-
RANGE: 10v
TPN-18 control panel
cated on clinometer.
SCAN: OFF
4-8