TM 11-5841-283-34-1/NAVAIR 16-30APR39-2
2-29. REPAIR OF CONTROL UNIT WIRE HARNESS.
This task covers:
Repair
INITIAL SETUP
Tools
Equipment Condition
Control unit cover off. See
Tool Kit, Electronic Equipment TK-105/G
Materials/Parts
Wire, type E-22, Rem 6,
Tie-down straps, item 7,
ACTION
REMARKS
ITEM
LOCATION
NOTE
The following procedure shows typical repair. All wires are
repaired in the same way.
Terminal lugs (1)
1. Control unit
and lead (2)
Using diagonal cutters, cut tie-down strap
Tie-down strap (3)
2. Wire harness
and remove lead.
and lead (2)
Install,
New lead (4) and
3.
Repeat steps 2 and 3 along wire
new tie-down
harness until old lead is removed and
strap (5)
new lead is installed.
4.
New lead (4) and
terminal lugs (1)
NOTE
See paragraph 2-19 for installation of cover onto case.
2-70
Previous Page
