TM 11-5840-281-12-1
Section VI PREPARATION FOR STORAGE AND SHIPMENT
Subject
Para
Page
General ......................................................................................................................................
Disassembly...............................................................................................................................
Administrative Storage.................................... ...........................................................................
Intermediate Storage..................................................................................................................
4-50. GENERAL.
This section gives procedures for disassembly and repacking of radar set. Before disassembly and repacking, the next
scheduled PMCS should be performed, all known problems corrected, and all current MWOs applied.
4-51. DISASSEMBLY.
The disassembly and repacking procedures given are to be used when radar set is not part of a landing control central
system. Refer to TM 11-5845-468-12 when radar set is part of Landing Control Central ANITSQ-71B.
Disassembly of radar set requires two personnel and a lifting device with suitable weight capacity.
Electronic Equipment Tool Kit TK-101/G is used for all disassembly procedures unless otherwise indicated.
CAUTION
A dust cover is provided for each cable connector and corresponding
receptacle. After disconnecting cables, install dust covers on connectors
and receptacles to prevent leakage of moisture into receptacles and
cables.
INTERCONNECTING CABLE DISCONNECTION
1.
Disconnect cable W3003 connected between receiver-transmitter and ac power distribution box and reel onto cable
reel no. 10.
2.
Disconnect cable W3004 connected between master control-indicator and ac power distribution box and reel onto
cable reel no. 11.
3.
Disconnect the following cables and reel onto cable reel no. 7:
Cable W3501 connected between receiver-transmitter and azimuth antenna drive
Cable W3502 connected between receiver-transmitter and azimuth antenna drive
Cable W3503 connected between receiver-transmitter and elevation antenna drive
Cables W9503, W9504, W9507, and W9501 connected between master control-indicator and slave control-
indicator
Ground cable W3006 connected between receiver-transmitter and ground rod.
4.
Disconnect cable W3001 connected between receiver-transmitter and master control-indicator and reel onto cable
reel no. 8.
5.
Disconnect cable W3002 connected between receiver-transmitter and master control-indicator and reel onto cable
reel no. 9.
6.
Disconnect cable W3005 connected between receiver-transmitter and master control-indicator and reel onto cable
reel no. 12.
7.
Disconnect cable W3007 connected between primary power source and ac power distribution box and reel onto
cable reel no. 12.
4-155
Previous Page
