TM 11-5840281-35/1
(59) Disconnect wires from connectors at
(63) Remove two screws (209), lockwashers
terminal boards.
(210), flat washers (211), terminal board (212), label
(60) Remove dust cap (192), four screws (193),
(213), and mounting plate (214) from elevation drive
lockwashers (194), flat washers (195), connector (196),
housing (215).
and gasket (197).
b. Assembly. To assemble Elevation Antenna Drive
(61) Remove four screws (198), lockwashers
TG-114/TPN-8, proceed as follows:
(199), flat washers (200), connector (201), and gasket
(1) Lubricate bearings (166 and 174) with grease
(202).
(MIL-23827).
(62) Remove two screws (203), lockwashers
(2) As cam shaft (165) is slowly slid into
(204), flat washers (205), terminal board (206), label
elevation antenna drive housing (215), stack bearing
(207), and mounting plate (208).
(174),
spacer(172),
cam
(172),
cam
(171),
Figure 5-13. Elevation Antenna Drive TG-114/TPN-8, exploded view (sheet 3 of 3).
5-44
Previous Page
