TM 11 40-281-35/1
Figure 5-13. Elevation Antenna Drive TG-114/TPN-8,exploded view (sheet 2 of 3).
ble resistor (165), hub clamp (156), and spur gear (157).
(54) Remove four nuts (175), screws (176),
(51) Remove three screws (158), lockwash-
lockwashers (177), flat washers (178), and identification
ers (159), fiat washers (160), cover (161), and gasket
plate (179).
(162).
(55) Remove four screws (180), lockwashers
(52) Loosen five hub clamps (163) and one hub
(181), flat washers (182), and lubrication plate (183).
clamp (164).
(56) Remove breather plug (184) and gasket
(53) Slide shaft (165) out of elevation drive
(185).
housing, removing bearing (166), spacer (167), spur
(57) Loosen six nuts (186), then remove screw
gear (168), cam (169), spur gear (170), cam (171), cam
(187) and nuts (186).
(172), spacer (173), bearing (174), and hub clamps.
(58) Remove level (188), two setscrews (189),
two posts (190), and two setscrews (191).
5-43
Previous Page
