TM 11-5840-281-35/1
Figure 5-14. Elevation drive motor, exploded view.
(2) Slide stator (15) into housing (16).
(3) Remove two retaining rings (5), bearings (6),
(3) Install bearing (11) and spacer (12) on rotor
shaft (7), arm assembly (8).
(10), then insert into housing (16).
(4) Remove two nuts (9), screws (10),
(4) Slide bearing (9), spring tension washer (8),
lockwashers (11), flat washers (12), and blocks (13 and
and shim (7) on rotor (10) shaft.
14).
(5) Install seal (6) in end bell (5), then install end
bell on housing (16) and secure in place with six screws
flat washers (17), one dowel pin (18), and slide cover
(3) and lockwashers (4).
(19).
(6) Attach identification plate (14) on housing
(6) Remove pin (20) then unscrew slide (21)
(16) using four drive screws (13).
from actuator and remove slide and washer (22).
(7) Place preformed packing (2) in position, then
install shaft cap (1) on housing (16).
flat washers (25), cover (26), and gasket (27).
(8) Remove screw (28), lockwasher (29), and flat
washer (30).
5-19.
Disassembly and
Assembly
of
10-35
(9) Remove screw (31), lockwasher (32), and flat
Actuator Assembly
washer (383).
(fig. 6-15)
(10) Remove nut (34), screw (35), lockwasher
(36), flat washer (37), switch (38), and adjusting plate
a. Disassembly. To disassemble 10-350 actuator,
(39).
proceed as follows:
(11) Remove screw (40), lockwasher (41), and
(1) Loosen nut (1) and remove rod end (2).
flat washer (42).
(2) Loosen nut (3) and remove rod (4).
5-50