TM 11-540-281-35/1
b. Assembly. To assemble Antenna Pedestal AB-
(7) Attach identification plate (6) to base (18)
738/TPN-8, proceed as follows:
using four screws (3), lockwashers (4), and flat washers
(1) Screw leveling jack (22) into leg (27).
(5).
(2) Screw locking collar (21) on leveling jack
(8) Attach six straps (13) to base (18) using one
(22).
nut (10), screw (11), and flat washer (12) for each strap.
(3) Slide handle (20) through hole in leveling jack
(22) and secure in place with two retaining rings (19).
NOTE
(4) Attach instruction plate (26) to leg (27) using
Shoulder screw (11) should allow strap
four screws (23), lockwashers (24), and flat washers
(13) to rotate when hardware is
(25).
tightened.
(5) Attach eye bolt (15) to base (18) using nut
(9) Position each leg assembly near base
(14), lockwasher (16), and flat washer (17).
assembly so other end of six straps (13) can be attached
(6) Attach three plates (2) to base (18) using
to leg assemblies using one nut (10), screw (11), and flat
nine screws (1).
washer (12) for each strap.
Figure 5-25. Radar target simulator, exploded view.
5-68
Previous Page
