TM 11-5840-360-14-1-1
Table 2-12 Switching Units Internal Jumpers (Cont'd)
Dual Radar (V4) Jumper List for Three Indicators
Dual Radar (V4) Jumper List for Three Indicators
(Cont'd)
(Cont'd)
II.
Indicator B (4/5)
1. a. With EBL remove link E1 to E2
b. Without EBL link E1 to E2
A. Video Amplifier A2A1
2. Remove link E3 to E4
1. a. With EBL remove link E1 to E2
B. Data Storage A2A3
b. Without EBL link E1 to E2
2. Remove link E3 to E4
1. Remove link E1 to E2
2. Remove link E3 to E4
B. Data Storage A2A3
3. With IR remove link E6 to E7
Without IR link E6 to E7
1. Remove link E1 to E2
C. PRF Generator A2A6
2. Remove link E3 to E4
1. Link E33 to E35 to a position E17
3. With IR remove link E6 to E7
through E26 (will be changed during
Without IR link E6 to E7
alignment)
C. PRF Generator A2A6
2. Link E32 to E34 to a position E17
1. Link E33 to E35 to a position E17
through E26 (will be changed during
through E26 (will change during
alignment)
alignment)
3. Link E40 to E36
2. Link E32 to E34 to a position E17
4. a. With IC socket bend pin 4 on U13
through E26 (will change during
(IC socket) (pin 4 disconnected)
alignment)
b. Without IC socket remove link E50
3. Link E40 to E36
to E51
4. Link E54 to E17 (may change during
5. Link E54 to E17 (may change during
alignment)
alignment)
5. Link E48 to E49
6. Link E48 to E49
6. Link E44 to E46
7. Link E44 to E46
D. VRMA2A7
D. VRMA2A7
1. Link E1 to E3
1. Link E1 to E3
E. Position Transmission A2A8
E. Position Transmission A2A8
1. Remove link E1 to E2
1. Remove link E1 to E2
2. Install U7
2. Install U7
3. Remove R62 and R63
F. EBL A2A9
F. EBL A2A9
1.
Link E2 to E4
1.
Link E2 to E4
2.
Link E8 to E10
2.
Link E8 to E10
3.
Link E13 to E15
3.
Link E13 to E16
4.
Link E16 to E17 (Rev. C and up only)
4.
Link E16 to E17 (Rev C and up only)
5.
Link E19 to E20
5.
Link E19 to E20
G. NSK Exciter A2A9
G. NSK Exciter A9A2
1. Link E1 to E2
1. Link E1 to E2
III.
Indicator C (4/5)
A. Video Amplifier A2A1
2-51
Previous Page
