TM 11-6625-1820-12
a. Adapter, Test MX-8743/APS-94D. The
module extender is 9.75 inches long with a con-
by the test set user.
nector on one end that mates with the module
the receiver-trans-
test set modules. This one module extender will
mitter module 2A11A2 is being tested.
extend any module in the module test for
b. Non-Magnetic Nut Driver. The non-mag-
servicing The module extender is stored in the
netic nut driver is a special tool for the test set
cover of the module test set (fig. 14).
user. It has a 7/16 hexagon socket with a hole
f. Power Meter 2A4 Primary Power Cable.
depth of 6 inches. The nut driver is used while
When the RF test set is in use, the power cable
replacing the magnetron in the receiver-trans-
connects primary ac power to power meter 2A4.
mitter. The nut driver is stored in the rf test set
The power cable is disconnected from the power
(fig. 2-3).
meter when the RF test set is to be shipped. The
c. socket Wrench. The socket wrench with did-
power meter power cable is stored in the RF test
ing bar handle is a special tool for use by the test
set (fig. 24).
set user. It has a deep socket and is used to re-
move the clenching rim clamp assemblies from
g. Mounting Hardware. The hardware fur-
the receiver-transmitter under test. The socket
nished with the RF test set is used to mount the
wrench is stored in the rf test set (fig. 2-3).
receiver-transmitter under test to the RF test set
d. Adapter, Test MX-8630/APS-94D. The
and subassembly 2A1 of the RF test set to the
module extender is 12 inches long with a connec-
receiver-transmitter. The mounting hardware is
tor on one end that mates with the control unit
stored in the RF test set (fig. 28).
Cable Assemblies
Previous Page
