5-3a.
Troubleshooting Test Set (Cont)
TM 11-6625-1831-13
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
7. CABLE DAMAGED.
Check extent of damage.
Repair or replace cable as necessary (para 5-7).
8. OPERATOR CONTROL (SWITCH, POTENTIOMETER) FAILS TO OPERATE SMOOTHLY.
Inspect for damage.
Replace control if necessary (para 5-6).
9. DDL-PROC SWITCH FAILS TO OPERATE SMOOTHLY.
Inspect for damage.
Replace switch if defective (para 5-10).
5-3b. Troubleshooting Test Panel
This task covers:
Correcting malfunctions found during electrical test of test panel
INITIAL SETUP:
Special Environmental Conditions
Test Equipment
None
Multimeter AN/USM-223
Tools
General Safety Instructions
Electronic Equipment Tool Kit
None
TK-105/G (Tool Kit)
Screwdriver, No. 2
Equipment Condition
Phillips
Offset Screwdriver,
Test set cover removed (para 5-4a)
No. 1 Phillips
Test panel removed (para 5-4a)
Printed Wiring Board
Repair Kit MX-772/U
References
Fig. FO-1 and FO-2
Electronic Card Extractor
(in storage compartment)
5-27
Previous Page
