TM 43-6625-916-12
RADAR TEST SET
0002 00
EQUIPMENT DESCRIPTION AND DATA - Continued
CE102
Power Leads, 10 kHz to 10 MHz
CS101
Power Leads, 30 Hz to 150 kHz
CS114
Bulk Cable Injection, 10 kHz to 200 MHz
CS115
Bulk Cable Injection, Impulse
CS116
Cables & Power Leads, Damped Sinusoidal Transients
RE101
Magnetic, 30 Hz to 100 kHz
RE102
Electric, 10 kHz to 18 GHz (exception 5 percent of RX/TX FRE
RE103
EXCEPTION: -50 dBc spurious limit, transmit harmonic levels are
not required to be lower than 10dB above the RE102 transmit
standby limits
RS101
Magnetic, 30 Hz to 100 kHz
RS103
Electric, 2 MHz to 40 GHz, 200 V/m
EXCEPTION: does not apply within 10% of RX and TX operating
User Interface
Display
16 character by 2 line alpha-numeric LED, 0.18" character height
with green Accept, red Reject, and yellow Battery indicators
Controls
3 buttons: test sequence advance, test sequence repeat, and test
result data
Transponder Test Modes
1
displays identification status
2
displays code, identification and emergency status
3/A
displays code, identification status
C
displays altitude, identification status
4
stand alone operation, but must be filled with challenge video
patterns from COMSEC, supports code A or B, A or B verify
S
Interrogates with: UF11, UF0, UF4 (requesting DF4), UF5,
UF16, UF4 (requesting DF20), UF21
Capable of upgrade to add IFF mode 5.
Interrogator Test Modes
1
responds with Code=12
2
responds with Code=1202
3/A
responds with Code=1203
C
responds with configurable altitude
4
requires KIT-1C to create correct reply
S
Replies to: UF11(all call),UF0 (short TCAS surveillance w/conf.
alt.), UF16 (long TCAS surveillance w/conf. alt.), UF4(conf.
altitude), UF5(Identity = 1204), UF20, UF21 Measures
interrogation rate
Capable of upgrade to add IFF mode 5.
Interrogator Target
Refer to Table 2-2.
Simulation
Previous Page
