TM-5840-281-35/1
(10) Remove four screws (38), lockwashers (39),
(15) Remove wire rope assembly (55).
flat washers (40), three flat washers (41), and bracket
(16) Remove pin (56), pin (57), and actuator (58).
(42).
(17) Remove nut (59) and rod end (60) from servo
(11) Remove two screws (43), lockwashers (44),
actuator.
flat washers (45), and guard (46).
NOTE
(12) Remove three screws (47), lockwashers (48),
Refer to paragraph 5-12 for disassembly
and flat washers (49).
procedures for the servo actuator.
(13) Remove two pins (50) and clinometer mount
(51).
(18) Remove retaining clip (61) and lift reflector
(14) Remove screw (52), lockwasher (53), and flat
from yoke.
washer (54).
5-13
Previous Page
