TM 11-5840-281-35/1
Figure 5-6. Elevation Antenna AS-1291/TPN-8 and yoke, exploded view (sheet 2 of 3).
(25) Remove pin (79) and upper pivot (80).
(19) Remove four nuts (62), screws (63), lock-
(26) Remove two screws (81), lockwashers (82),
washers (64), flat washers (65), and dial (66) from
flat washers (83), and clamps (84).
reflector.
(27) Remove four screws (85), lockwashers (86),
(20) Remove plug (67) from reflector (68).
flat washers (87), and identification plate (88) from yoke
(21) Remove four screws (69), lockwashers (70),
(89).
and flat washers (71).
b. Assembly. To assemble elevation Antenna AS-
(22) Separate actuator bracket (72) from yoke.
1291/TPN-8 and yoke, proceed as follows:
(23) Remove two screws (73), lockwashers (74),
(1) Attach identification plate (88) to yoke (89) using
flat washers (75), and pointer (76).
four screws (85), lockwashers (86), and flat washers
(24) Remove pin (77) and lower pivot (78).
(87).
5-14
Previous Page
