Bulk and Consumable Materials.
Cloth, cheesecloth, lint-free
8. Special Tools, Jigs and Fixtures Required. Not applicable.
9. Inspection Procedures. Only applicable to Tactical Airspace Integration System redeploying.
10. Cleaning Procedures.
Keep in mind all warnings and cautions when performing any routine cleaning
IMPROPER CLEANING HAZARD
This equipment can be damaged by improper cleaning.
Use only soft cloth slightly dampened with water or mild glass cleaner.
Do not scrape with hard plastic or metal tools.
Do not use alcohol, toluene, acetone, methyl ethyl ketone (MEK), volatile liquids, or harsh
Do not use scouring powder or other gritty cleansers.
a. Using a lint-free cloth, clean exterior surfaces of equipment and mechanical assemblies.
b. With a clean lint-free cloth and soft-bristled brush, clean plugs, jacks, and front panel controls and
indicators. Meter faces and front panels may be cleaned using a weak solution of water and mild soap.
Avoid excessive amount of solution on cloth and do not let solution enter behind controls or panel
mounting hardware of controls and indicators.
Clean exterior and pins of connectors of interconnecting cables with a brush.
Generator and trailer (refer to TM 9-6115-661-13&P)
Power vault, racks, DTS (refer to TM M1139)
Filters: ADSI processor filter / UPS air filter / Ultra 80 workstation / ECU (includes fresh air filter) / voice
recorder (two filters) - wash filter in warm water using mild detergent, rinse, shake off excess and allow
Inspect/clean as needed - ECU drain hose, radios, secure phones, UPS, AccessNet main switch,
Access points, printer, GPS
Monitors - Wipe monitor screen with lint-free cloth dampened with glass cleaner or water.
11. Weight and Balance. Not applicable.
12. Recording and Reporting Requirements. Not applicable.
13. Points of Contact.
Point of contact for this action is ATSCOM, ATTN:AFATS-S4-MR DSN 558-3494 or Commercial 334-
Technical point of contact is ATSCOM, ATTN:AFATS-S4-MR DSN 558-3494 or Commercial 334-255-