TM 11-5840-281-12-1
CHAPTER 3
OPERATOR MAINTENANCE
Subject
Section
Page
Operator Troubleshooting Procedures ...........................................................................................
Operator Maintenance Procedures ................................................................................................
Section I OPERATOR TROUBLESHOOTING PROCEDURES
This section contains general troubleshooting Information for the operator of the radar set. If a problem is observed,
proceed with the following corrective actions:
Check that all controls, switches, and circuit breakers are In the correct position for the mode of operation you are in.
Check that all cables and connectors are connected properly.
Check that primary power source Is supplying power to the radar set.
The corrective actions above may not solve all the problems you may observe. If corrective actions do not solve your
problem, report problem to a higher level of maintenance.
Section II OPERATOR MAINTENANCE PROCEDURES
Subject
Para
Page
General ...................................................................................................................................
Cleaning and Inspection ..........................................................................................................
Cursor Alinement Checks ........................................................................................................
Dehydrator Cartridge Inspection ..............................................................................................
Operational Check ..................................................................................................................
Front Panel and Indicator Lamp Replacement.........................................................................
Fuse Replacement ..................................................................................................................
3-1
Previous Page
