TM 11-5840-281-35/1
to replace the coaxial cable, new connectors must be
cables, it is usually more practical to use new
used, since the gasket (in most cases) is not reusable
connectors. It is possible to use the old connectors
and cannot be obtained as a separate item. See figure
provided the old excess solder is properly removed, no
solder spray is present on rear of connector, pins are
clean and not tarnished, and connector and its parts are
not otherwise unserviceable.
After replacement of
5-6.
Interconnecting Cable Repair (fig. -3)
connectors, always make a pin-to-pin continuity check
between applicable connectors. See figure 5-3 for
Interconnecting cables are repaired by replacing the end
typical interconnecting cable repair instruction
connectors or the cable. When repairing multiconductor
Figure 5-3. Interconnecting cable repair (typical)
5-4
Previous Page
