TM 43-6625-916-12
RADAR TEST SET
BENCH UTILITY
INTRODUCTION
The TS-4530/UPM Bench Utility (PN: 60-0694-B5) is designed to allow remote access to the TS-4530/UPM.
This program can be used to download and view test data records stored in the unit.
INSTALLATION
Minimum System Requirements:
IBM PC compatible
Comm 1 Serial port capable of 9,600 baud rate
90 MHz Intel Pentium processor (or better) with one of the following:
Microsoft Windows 95/98
NT4.x with Service Pack 3 or above
NT2000
CD-ROM drive
10 Meg hard drive space
16 Meg RAM (32 Meg recommended)
Mouse
800 x 600 VGA graphics (or better)
NOTE
Any serial port (Comm 1 4) may be used with this Software. The program
will search Comm ports 1 through 4, to find the unit.
NOTE
Prior to installing this software on a computer, all previous versions of this
software must be uninstalled from the target computer first.
To uninstall a previous version of this software, click on the Start Menu and
select "Settings", "Control Panel", then "Add/Remove Programs". In the
program list box that appears, locate and select TS-4530/UPM Bench Utility,
then click the "Add/Remove" Button.
Insert the supplied CD-ROM for the TS-4530/UPM Bench Utility into the CD-ROM drive. On most computers,
the installation process will begin automatically. On some computers, the installation will not begin
automatically and the program installation must be started manually.
To manually start the installation process, click on the Start Menu and select "Run". In the dialog box that
appears, type the following:
D:\setup
where D is the drive letter of the CD-ROM drive on the computer. After typing the above, click "OK".
Previous Page
