TM 11-6625-1831-13
CHAPTER 3
ORGANIZATIONAL MAINTENANCE
Page
Page
Chapter Overview ........................................... 3-1
Organizational Preventive Maintenance
Introduction ..................................................... 3-1
Checks and Services..................................
Repair Parts, Tools, and Support
Organizational Maintenance ..........................
Equipment .............................................
Preparation for Storage or Shipment .............
Repainting and Refinishing......................
CHAPTER OVERVIEW
This chapter describes the maintenance to be performed at the organizational level.
3-1. INTRODUCTION
Organizational maintenance persons are responsible for inspecting the test set on a regular schedule. Use the Preventive
Maintenance Checks and Services chart in paragraph 3-4 as a guide.
No organizational troubleshooting is required.
The only organizational maintenance procedure needed is cleaning the test set. These instructions are in paragraph 3-5.
Organizational maintenance persons can repaint and refinish the test set case if needed. The necessary information is in
Each table in this chapter has an INITIAL SETUP section. This section gives information you need before you start the
procedure.
Resources required are not listed unless they apply to the procedure.
Personnel are listed only if the task required more than one. If PERSONNEL is not listed, it means one person can do the
task.
The normal standard equipment condition to start a maintenance task is with power off. EQUIPMENT CONDITION is not
listed unless some other condition is required besides the power being off.
3-1
Previous Page
