TM 43-6625-916-12
RADAR TEST SET
0006 00
OPERATION UNDER USUAL CONDITIONS - Continued
Table 6-9. Interrogator/TCAS Automatic Tests - Continued
STEP
BUTTONS PRESSED
RESULTS/REMARKS
The operator can go to the Interrogator
Temp Setup by pressing S2 for at least 3
seconds and releasing. Refer to
Store results (if desired).
Pressing the S1 button when
Once the test sequence has been
all formats are completed at
completed, the operator is given the
the end of the automatic
option to save the test data to memory. If
testing provides the "Save
saved, the test number is displayed. In
Test Data?" screen. This
order to correlate the test results with the
screen provides YES and NO
test aircraft/weapons system the operator
options.
must record the test number and aircraft
tail number. The data can be
The S2 button then serves as
downloaded to a PC when testing has
a toggle switch between YES
been completed.
and NO. Press S1 to execute.
If desired, download and
Go to WP0008 00.
view/print stored results using
the bench utility (WP0008 00).
STEP
BUTTONS PRESSED
RESULTS/REMARKS
From the "Device to test
"Inter Test Scenario?" screen is shown.
NOTE
Transponder" screen, go to
the "Inter Test Scenario?"
It may be necessary to
The operator can go to the Interrogator
screen.
press S2 to navigate to the
Temp Setup by pressing S2 for at least 3
appropriate interrogator
seconds and releasing. Refer to
test menu screen because
the Test Set retains the
previous state of the last
test or action performed.
Press S2, S1. Then press S2
then number of times
necessary to cycle to the "Inter
Test Scenario?" screen.
For Inter Test Scenario, S1
Press S1 for the desired
Pressing S2 will repeat the selected test.
sequences through ATCRBS
ATCRBS and Mode S checks.
level, dive, climb, above, and
Pressing S3 when in a test will display the
Mode S level, dive, climb,
scenario status (range and altitude) while
above.
in the selected test. Pressing S3 again
will toggle back to the selected test
screen.
Previous Page
